PRESIDIUM Multi Tester III Manual Del Usuario página 12

Turning on your Presidium Multi Tester III
Remove the protective cover from the probe tip (Fig.1.3).
Fig. 1.3
Press the [ON/OFF] button located at the back of the
tester (Fig. 1.4). and wait for about 20 seconds to warm
up the instrument.
Fig. 1.4
While in this preparation mode, a Green light will blink
continuously. The light will stop blinking when it is
"READY" to be used (Fig. 1.5).
Fig. 1.5
The tester will shut down automatically after 10 minutes
of inactivity.
11