FF Europe PPCM03 Manual De Instrucciones página 13

IMPORTANT MEASURES
When electrical equipment is used, basic safety measures must be taken,
including the following:
1.
Read all instructions before operating this equipment.
2.
Keep the main unit door closed while it is operating. Do not touch the cauldron while operating the
equipment, it becomes VERY HOT
3.
To protect against electric shock, do not immerse the power cord, plug, or any other part of this
equipment in water or other liquids.
4.
To avoid the risk of fire or electric shock and damage to the unit, this unit should ONLY be plugged into
a polarized alternating current outlet of 220-240 Volts.
5.
When the equipment is being used near children, close supervision is necessary.
6.
Unplug from outlet when not in use, before removing parts and before cleaning.
7.
DO NOT operate any appliance if it has a damaged cord or plug, or if the equip-ment has been damaged
in any way. Take the equipment to the nearest repair shop for revision or repair.
8.
The manufacturer does not recommend the use of accessory attachments. The use of these can cause
injuries.
9.
DO NOT use it outdoors.
10.
Place the equipment as close to the outlet as possible to avoid injury from trip-ping over the power
cord.
11.
DO NOT leave the boiler engine working once the popcorn explosion has ceased.
12.
Extreme care must be taken when moving this equipment.
13.
DO NOT use the equipment for any purpose other than that for which it is in-tended.
14.
Equipment that is plugged into an outlet should not be left unattended while is functioning.
15.
Before using the cauldron check that there are no any objects in it.
16.
Make sure that the cauldron is properly positioned in the supports before oper-ating it and that the
motor plug is plugged into the cauldron.
17.
A short power cord is provided to reduce the risk of tangling or tripping.
18.
Power supply extension cords can be used if care is taken in their use
19.
The electrical classification indicated on an extension must be at least the same value as the electrical
rating of the device.
EN
13