Outputs; Mechanical Data; Environmental Conditions - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

Input for resistance
Ranges
0 ... 400 Ω
Resistance
0 ... 4000 Ω
Resistance
Resolution 14 bit
Measuremend mode 2 wire, 3 wire and 4 wire
technology, programmable
800 µA at 400 Ω
Current
80 µA at 4000 Ω
Voltage measurement
Ranges
Voltage 0 .. +100 mV DC
Voltage –100 .. +100 mV DC
Resolution 14 bit
Input resistance > 2 MΩ
Further data for the measurement input
A/D transducer Dual-Slope
Measuring speed approx.. 1 measurement/sec
Zero adjustment automatically
Digital input
Input MPI* Function of the input depends on set-up
1. Function: Display-Hold to stop the instantaneous value
2. Function Reset Reset the alarm value
Alarm Latch
*Multi Purpose Input
Input Key Keypad lock-out of alarm settings
Switching level
logical 0 0 ... 2 V DC
logical 1 4 ... 30 V DC
Min. pulse duration > 5 ms
The MPI Input is galvanically isolated from the rest of the unit´s electronics

2.2.3 Outputs

Alarm 1/Alarm output 2
Relay output with volt-free changeover contacts
can be setup as normally closed or normally open
Switching voltage 250 V AC/300 V DC
Switching current max. 3 A AC/DC, min. 30 mA DC
2000 VA / 50 Ω
Switching power
Page 6
Accuracy
± 0,2 Ω
± 2,0 Ω
Accuracy
< 0,1% ± 1 Digit
< 0,1% ± 1 Digit
or NPN-optocoupler with open collector and open emitter
Switching power 30 V DC/15 mA
U at Ic = 15 mA max. 2.0 V DC
CEsat
U at Ic = 5 mA max. 0.4 V DC
CEsat
Auxiliary power supply output for measuring transducer/sensor
AC models
voltage output 10 V DC ±2%, 30 mA
and
voltage output 24 V DC ±15%, 50 mA
DC models only voltage output 10 V DC ±2%, 30 mA
The auxiliary power supply is galvanically isolated from the inputs and outputs.

2.3 Mechanical Data

Housing Housing for control panel 96 x 48 mm according to
DIN 43 700, RAL 7021
Dimensions (W x H x D) 96 x 48 x 90 mm
Panel cut-out (B x H) 92 +0,8 x 45
Mounting depth approximately 83 mm
Weight approximately 220 g
Protection IP 65 (on the front side)
Connections
Power supply and output: 1 x screw terminal, 8-pole, RM 5.08
Measurement and control input: 1 x screw terminal, 11-pole, RM 3.81
Cleaning: The front of the unit is only to be cleaned
with a soft wet (water !) cloth.

2.4 Environmental conditions

Ambient temperature –10°C ... +50°C
Storage temperature –20°C ... +70°C
Climatic stability relative humidity < 75%, without condensation
+0,6 mm
Seite 7