Setting The Scaling Slope - Phoenix Contact MCR-FLP-D-T-2SP-24 Manual Del Usuario

Upper limit
Menu <–> Selection
Example: 80.000
Select digit
Set digit
press key to accept the selection
5.3.4.3 Changing the scaling slope
Menu <–> Selection
use the current scaling slope
➱
5.5 Monitoring parameter

Setting the scaling slope

➱
5.4 Monitoring parameter
press key to accept the selection
5.4 Setting the Scaling Slope
At least two points (2 pairs of values) are
required for the start point and end point of
the scaling slope. This slope can be rising
or falling. A maximum of 24 scaling points
can be used.
However it should be noted that in all
cases, whether the slope rises or falls, the
values that are inputted (Inp.01 ... InP.24)
must increase sequentially.
Page 18
When the input signal exceeds the value
set here, than is displayed.
Over-range: When the value exceeds
109 mV then is displayed.
21
18
The scaling slope must lie within the limits
of the input and display ranges. The first
and last points can lie on the limits.
Input range –100 ... +100 mV
Example with 4 scaling points
Input range –100 ... +100 mV
knee input- display
points value value
1 –50,000 –250,0
2 20,000 300,0
3 70,000 700,0
4 80,000 950,0
We will use this example in the following
pages
Display range
It is recommended to note down the
required pairs of values for the sca-
ling points of the slope before star-
ting the set-up.
Page 19