Basic Setup; Wall Mounting - Doro 915c Syntiro Manual De Instrucciones

Connection
1. Connect the curly cord to the handset and to
the socket marked y on the telephone.
. Connect the telephone line cord to a
network wall socket and to the K socket
on the back of the telephone.
3. Connect the mains adapter to the mains
power wall socket and to the DC 9V socket
on the telephone.
4. Lift the handset and listen for the dial tone.
IMPORTANT: Use the telephone line cord
supplied, an existing line cord from a
previous phone may not be compatible
Batteries
Four AAA alkaline batteries are needed as
backup for the call memory and speakerphone.
BATT. LOW
When is displayed, replace all 4
batteries. Use only AAA alkaline batteries of
good quality (not included).
Note!
Before installing or changing the
batteries, make sure that the telephone is
not connected to the telephone network.
1. Remove the battery cover and insert the
batteries ensuring correct battery polarity
is observed.
. Replace the battery cover and reconnect
the telephone line cord.

Basic setup

Before using the telephone the first time, the
following basic settings should be made.
After confirming a setting, the next setting is
automatically displayed. To skip to the next
setting, press
The phone will return to standby mode after
30 seconds of inactivity or when pressing C.
On first setup the display will show
1. Press and hold * for about 5 seconds
until the hour flashes.
Use v / V to change the value and
.
confirm with
3. Repeat step  to set the minutes, day and
month.
Installation
.
00:00
.
English
ENGLISH
is displayed.
Use v / V to select the desired language,
then confirm with
-2- CONTRAST
Use v / V to set the display contrast
setting (1–4), and confirm with
KEYT. ON
Use v / V to set key tone ON/OFF, and
confirm with
-100- FLASH
Use v / V to set the flash key time
(100/300/600 ms) and confirm with
The standard setting is 100 for most
countries, 300 for France/Portugal, 600 for
New Zealand.
LED OFF
Use v / V to enable/disable the LED
indicator for new calls, and confirm with
TONE
Use v / V to select either tone or pulse
dialling mode, and confirm with
Note!
If unsure of which mode to use, select
TONE as this works in most locations.
-1-RING TYPE
Use v / V to select one of 3 ring tones,
and confirm with
Basic setup is now complete

Wall mounting

The telephone can be wall mounted using an
optional wall mount bracket. The wall mount
bracket is available as an accessory, part
number WB00/300 in white or black.
1. Fix the wall mount bracket on the back of
.
the telephone.
. Secure two screws, vertically positioned 83
mm apart.
3. Activate the hanging peg (located by the
hook switch) by rotating it 180 degrees.

.
.
.
and confirm with
.
.
.
.