Publicidad
TP755-769 Rapide IN8286-E 07 15.qxp_TP755-769 Rapide IN8286-E 07 15 09/07/2015 15:54 Page 4
1
INSTRUCTIONS FOR ASSEMBLY, MAINTENANCE AND USE OF TP TOYS
Please read carefully and keep all enclosed information or future reference.
1. ASSEMBLY AND SAFETY INFORMATION
TP toys must be assembled by an adult. They must be erected exactly in accordance with the assembly instructions. Enlisting the aid of a
helper will make assembly easier. This pack may contain small parts and is not suitable for children under 36 months. We recommend
that you place small parts on a tray, or something similar, to prevent the frustration and disappointment of mislaying them. Please take
care during assembly as the manufacturing process can sometimes result in the occasional sharp edge and small pieces of waste
metalwork. Should there be any missing parts, the toy must not be used until replacement parts have been fitted - the TP Customer
Services line is: E-mail: directsales@tptoys.com
2. SITING
Under no circumstances should any of our toys be positioned on hard surface such as concrete or asphalt, unless the ground under the
toy plus the recommended freespace area is covered with a safety surface (please refer to diagram on page 15). Examples of suitable
surfaces are grass, sand or a play surface intended for this use. TP toys should be sited on level ground.
3. USAGE
TP toys are designed and made for use only by children aged between 3 and 14 years, unless otherwise stated, and must not be used by
anybody else. Misuse can result in injury. Warning only for Domestic use. For outdoor use only.
4. SUPERVISION
Children should always be supervised while they are playing on TP toys and should be instructed not to use the toy in an inappropriate or
hazardous manner. We recommend that they do not wear loose-fitting clothing or jewellery than may catch or snag during play. Children
should not wear cycle helmets while playing on TP toys.
5. WEATHER CONDITIONS
Special care should be taken as weather conditions change. In particular, outdoor toys can become slippery in wet weather and tongues
and lips can stick to metalwork at subzero temperatures. In warmer and sunnier weather, parts can become hot, and the temperature
should be regularly checked during play, especially metal parts and slides. If there is any doubt over safety then the toys should not be
used.
6. MAINTENANCE.
With all toys it is vital that the equipment is checked regularly and often by an adult. The complete toy should be checked at least once a
month, and particular attention should be paid to connections and fastenings. If any parts exhibit signs of wear and tear, they may need
to be replaced. Checks must be carried out at the beginning of the usage season as well as at regular intervals throughout the usage
season. Check all nuts and bolts for tightness and tighten when required. Failure to do this may result in the product malfunctioning and
causing injury. Children must not be allowed to use the toy until properly installed and checked. Galvanised tubular products may require
occasional maintenance. If surface rust appears it should be removed with either a wire brush or coarse sandpaper, and the area treated
with a non-toxic paint.
7. FIRE RISKS AND DISPOSAL
Never allow TP toys to be placed or used near a fire. When it becomes necessary to dispose of your equipment, remove all bolts and
disassemble. Store out of the reach of children until it can be properly disposed of.
These instructions are issued in the interest of child safety, and we do ask you to follow our advice.
10
20
30
40
Dimensions in mm
50
60
70
80
90
4
100
Rapide Slide
Publicidad
