Publicidad
Idiomas disponibles
Idiomas disponibles
Step 9: Add Bar Brackets
Note: If the Support Bar was not installed in Step 8, only re-install the cross tube in this step.
Slide the lower Cross Tube through the first Monitor Bracket, first Bar Bracket (e), both Axis Assemblies, a second Bar Bracket and
through the second Monitor Bracket. Tighten all four Vise Assemblies to secure the Cross Tube once it is slid through the second Moni-
tor Bracket. Thread each 1/4 - 20 x 5/8 Bolt (k) through each hole in the bottom of the Axis Bracket (d) until they bottom out against the
Support Bar (g). See Diagram 9 below.
Step 10: Configure Speaker Attachments - Support Bar Not installed. If using Support Bar, see Step 5 for configuration.
Configure the Speaker Attachments as seen below. Tighten all Bolts with a Phillips screw driver. Repeat process for the second Speaker
Attachment. See Diagrams below. The Extensions (a,b,c) can be adjusted vertically to adjust the vertical position of the speaker. The
depth of the speaker can be adjusted by using the front set of holes or the back set of holes in the Speaker Bracket (f). The Upper Exten-
sions can be adjusted using the slot in the top to adjust the depth of the speaker. Note: In rare occasions, the Lower Extensions may not
be used.
Configuration 3
j
c
f
VMCC1ins_010606_ML.indd 8
Diagram 9
a
j
Detailed View
g
d
k
Configuration 4
b
j
c
j
f
1/16/06 10:32:02 AM
Publicidad
