Publicidad
Idiomas disponibles
Idiomas disponibles
3. To cancel the set point programming mode at any
time, press and release the time button. The
display will change to show the actual platen
temperature. See figure 9.
figure 9
Programming Toast Times
1. Press and hold the time button for 6 seconds. A
beep will sound, and the time indicator light will
blink. Release the time button to show the
current toast time. See figure 10.
figure 10
2. Use the up and down arrow buttons to set your
desired toast time. The range is from 20 seconds
to 1 minute, 30 seconds. When desired time is
reached, press and release the time button to
store the new time. See figure 11.
figure 11
SETTING THE NEW TIME
STORING THE NEW TIME
2 1 5
5 5
3 5
3 5
3. To cancel the time set function at any time, press and
release the temperature button. The time indicator
light will turn off, and the display will change to show
the actual platen temperature. See figure 12.
figure 12
SETTING STOP BLOCKS
Stop blocks allow for proper crush when toasting
buns. The toaster leaves the factory with the stop
blocks set on R/Q.
Dual stop blocks allow you to switch back and forth
from Reg/Qtr. bun and Big Mac Bun toasting, or Rib
bun or Rye bun toasting.
1. Ensure the stop blocks are on the correct setting.
There are (6) combination Stop Block Settings:
1. R/Q / MAC
2. R/Q+ / MAC +
3. R/Q- / MAC -
THE (+) SETTING IS FOR BUNS THAT ARE CUT
TOO THICK. THE (-) SETTING IS FOR BUNS CUT
TOO THIN. FOR NORMAL SIZE BUNS DO NOT USE
(+) or (-) SETTINGS.
[R/Q = REG/QTR]
2. Rotate stop blocks by hand to the desired
combination bun setting listed above.
3. View the stop block setting selected through the
index window bracket, which is located over the
left stop block. See figure 13.
figure 13
SIDE PANEL
INDEX WINDOW BRACKET
7
2 1 5
4. RIB / RYE
5. RIB+ / RYE +
6. RIB- / RYE -
STOP BLOCK
BUN SETTING
(REGULAR BUNS)
Publicidad
