NIXON The Blaster Pro Manual Del Usuario página 5

The Blaster Pro Layout
Power
Button
Multi
Button
Power LED
(Red/Yellow)
Charging
Port
(Micro-USB)
Aux Input
(3.5mm stereo)
Volume
Down Next Track
Volume Up
Bluetooth ® LED
(Blue)
Power it up
Hold 3 seconds
Press and hold the Power Button for 3 seconds then release
to power ON The Blaster Pro. The Power LED will illuminate
solid.
Press the Power Button again for 3 seconds then release to
power OFF.
NOTE: The Blaster Pro will enter Power Saving Mode to after
10 minutes of no music playback. If the battery is also low, it
will power OFF completely to save the remaining battery.
Sync it up
Hold 2 seconds
Press and hold the Multi Button for 2 seconds then release to
enter Bluetooth
Previous
and the Bluetooth
Track
Now locate the Bluetooth
enable Bluetooth
®
Bluetooth devices.
When Bluetooth
stop flashing and illuminate solid.
NOTE: If your music device supports automatic Bluetooth
connection requests, The Blaster Pro may ask your music
device to connect. Simply confirm by selecting "OK" on your
music device.
If your music device does not support Bluetooth
connections, use the included AUX Audio Cable to play music
directly to The Blaster Pro.
NOTE: When using the AUX input of The Blaster Pro, the
Bluetooth audio signal is disconnected, and the remote
control buttons and internal microphone will not function.
® Pairing Mode. The speaker will sound a tone
® LED will flash repeatedly.
® settings on your music device,
® , and then select "V" from the list of local
® pairing is successful, the Bluetooth LED will
®
®