Use 2; Programming Your Remote Control - SOMFY SITUO 1 RTS Manual De Instalación Rápida

Short press On
Short press –
Short press Off
3.1 Programming a Somfy RTS remote-controlled lamp holder or socket
Programming a remote control
1.
Check that the remote-controlled lamp holder/socket is switched on.
During this operation, disconnect all other lamp holders and sockets for Somfy remote-controlled devices in your home.
2. Press the channel selection button as many times as necessary until the indicator lights show the channel to
be programmed.
3.
Press the programming button on the remote-controlled lamp holder/socket until the indicator light flashes.
4. Use a fine-tipped object to apply a short press on the PROG button on the back of the remote control.
The indicator light on the remote-controlled lamp holder/socket will come on permanently, then go off.
2
Examples of Somfy RTS remote-controlled lamp holders and sockets
On/Off socket
ON/OFF lamp holder
Micro-module
Lighting receiver

PROGRAMMING YOUR REMOTE CONTROL

3
EN - Installation and operating manual RTS 1 channel - 5 channel remote controls - SOMFY
Roller shutter
Hinged shutter
Open
• Stop if the shutter is moving
• Favourite position saved if the shutter
is open or closed
Close
4

USE 2

3
4