3.2 Programming A Somfy Rts Roller Shutter Or Hinged Shutter Drive - SOMFY SITUO 1 RTS Manual De Instalación Rápida

3
PROGRAMMING YOUR REMOTE CONTROL

3.2 Programming a Somfy RTS roller shutter or hinged shutter drive

You must first have commissioned your shutter drive.
Before any programming, the end limits for your motor must have been set (refer to the motor
instructions, or contact Somfy assistance). Check the direction of rotation: press the
If the shutter is lowered / closes, refer to the motor instructions or contact Somfy assistance.
Programming a remote control
1.
Identify the shutter's original control, i.e. the remote control or control point
which controls only this shutter.
- If the original control has been lost or broken and it is the only one for controlling the shutter,
contact Somfy assistance.
- If another control operates the roller shutter only, use that to follow the steps below.
2.
Partially open the shutter using the original control.
3.
Press the PROG button on the original control until the shutter makes an up and down movement.
The programming function is activated for 2 minutes.
4.
Press the channel selection button as many times as necessary until the indicator lights show the channel to
be programmed.
5. Use a fine-tipped object to apply a short press on the PROG button on the back of the remote control to be added.
The shutter moves up and down.
Original control
3
Remote control to be added
4
Saving or altering the favourite position
Consult the instructions for your shutter motor.
EN - Installation and operating manual RTS 1 channel - 5 channel remote controls - SOMFY
5
or
Back of
control point
5
Back of
remote control
button.
or
or