Technical Specifications - Perel Tools GMK2 Manual Del Usuario

3. Use
• Place the mosquito trap on a flat and stable surface. For best results, install the mosquito trap approximately
1.5m above the ground.
• Connect the mosquito trap to the mains.
• Switch the mosquito trap on or off with the on/off switch.
• Empty the mosquito trap.
4. Emptying and Cleaning the Mosquito Trap
Turn the base in an anticlockwise direction. Clean out the base using the
included brush.
Clean the fan using the included brush or a slightly damp cloth.
5. Replacing the UV-lamp
Refer to the pictures on page 2 of this manual.
• Switch off the lamp and disconnect the mains.
• Remove the collecting container (1). To do this, twist the container counter clockwise and pull (see picture A).
• Remove the 4 screws that keep the lamp holder section (2) and fan section (3) together (see picture B).
• Pull the lamp holder section (2) and fan section (3) apart. Be careful not to damage the electrical leads. The
cone (4) can also be removed if necessary (see picture C).
• To remove the UV-lamp, gently turn it a quarter and pull it out of the sockets.
• Place the new UV lamp in the sockets and turn a quarter to secure it.
• Re-position the cone (4), guiding the electricity leads through the gap.
• Put the lamp holder section (2) on top of the fan section (3) with the screw holes lined up, making sure the
electrical leads don't get damaged. Push until a click is heard and remount the 4 screws.
• Re-install the collecting container (1). Place it on the fan section (3) and turn clockwise until it is secured.

6. Technical Specifications

Power Supply
Power Consumption
Dimensions
Total Weight
Velleman nv cannot be held responsible in the event of damage or injury resulted from (incorrect) use of
this device.
For more info concerning this product, please visit our website www.perel.eu.
The information in this manual is subject to change without prior notice.
GMK2_v2
All manuals and user guides at all-guides.com
Separate the fan from the upper part using an appropriate Phillips-head
220 ~ 240VAC/50Hz
26W
250 x 250 x 320mm
1.7kg
Clean the UV lamp using the included brush.
4
screwdriver.
PEREL