Check Direction Of Rotation Of Motor [Lsv 8] (11); Reversing Phases Of The Mains Voltage [Lsv 8] (12) - AL-KO LSV 6 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 120
Start-up
WARNING!
Danger of injury if the
appliance tips over
A tipping appliance can re-
sult in serious injury and
damage to the appliance.
Ensure that the appli-
ance cannot tip over.
1. Stand the log splitter horizontally on a level,
firm surface. Do not place the log cutter on
the mains cable!
Note: Do not place any material under the
log splitter to change the height of the appli-
ance or to try to increase its stability. If the
log splitter is not level and/or is unstable, it
must be moved to another location. Opera-
tion on soft ground such as lawns or gravel is
not permitted as the appliance could sink in
and/or tip over during operation.
2. Lay the mains cable in such a way that it can-
not be kinked, crushed or damaged in any
other way.
3. Plug the mains cable into plug socket (01/6)
of the appliance and then connect the mains
cable to the mains power supply.
Note: During disconnection, first disconnect
the mains cable from the mains power sup-
ply.
442310_a
6.2
Check direction of rotation of motor
[LSV 8] (11)
IMPORTANT!
Danger of damage to the
hydraulic pump
The hydraulic pump will be
damaged if the motor ro-
tates in the wrong direc-
tion.
Switch off the log splitter
again immediately if the
motor rotates in the
wrong direction or the
splitting wedge does not
move upwards after
switching on.
Reverse the phases of
the mains voltage.
1. At the same time:
Press green button (11/1) and then red
button (11/2) to allow the motor to run
briefly.
Observe the direction of rotation of the
motor through ventilation slots (11/3).
The direction of rotation must correspond
to the arrow (11/4) on the motor.
2. If the direction of rotation does not corre-
spond: see chapter 6.3 "Reversing phases of
the mains voltage [LSV 8] (12)", page 41.
6.3
Reversing phases of the mains voltage
[LSV 8] (12)
1. Switch off the log splitter immediately and un-
plug the mains cable.
2. Insert a flat-tip screwdriver into phase invert-
er (12/1) in mains plug socket (12/2) of the
log splitter.
3. Press in the phase inverter and turn by 180°.
4. Plug in the mains cable.
5. Switch on the log splitter and check the direc-
tion of rotation of the motor again. The split-
ting wedge must move upwards.
41

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Lsv 7Lsv 8113602113603113601

Tabla de contenido