Operating Instructions - Kobalt KT200A Manual Del Usuario

OPERATING INSTRUCTIONS

TO ATTACH BATTERY PACK (Fig. 1)
1. Place the direction-of-rotation selector ( B ) in the center
( locked ) position.
2. Align the raised portion on the battery pack (G) with
the grooves on the bottom of the drill/driver, and then
slide the battery pack onto the drill/driver as shown.
3. Make sure that the latch on the battery pack snaps into
place and the battery pack is secured to the drill/driver
before beginning operation.
NOTE: When placing the battery pack on the tool, be
sure that the raised rib on battery pack aligns with the
groove on the drill/driver and the latches snap into place
properly. Improper assembly of the battery pack can
cause damage to internal components.
TO DETACH BATTERY PACK (Fig. 1)
1. Make sure that the trigger switch (A) is in the "OFF"
position.
2. Press the battery-release button (H) to release the
battery pack.
3. Pull forward on the battery pack to remove it from the
drill/driver.
WARNING: Battery tools are always in operating
condition. Therefore, the direction-of-rotation selector
should always be locked (center) when the tool is not in
use or when carrying the tool at your side.
TRIGGER SWITCH (Fig. 2)
To turn the drill/driver ON, depress the trigger switch (A).
To turn it OFF, release the trigger switch.
VARIABLE SPEED
The variable-speed trigger switch delivers higher speed
with increased trigger pressure and lower speed with
decreased trigger pressure.
TWO-SPEED GEAR BOX (Fig. 3)
The drill/driver has a two-speed gear box designed for
drilling or driving at two different variable-speed ranges.
A gear selector (F) is located on the top of the drill/driver
to select either 1 (Low) or 2 (High) speed.
When set to 1, the drill/driver will deliver lower speeds
and increased power and torque.
When set to 2, the drill/driver will deliver higher speeds
and reduced power and torque.
Use 1 for high power and high torque applications and 2
for fast drilling or driving applications.
1
2
3
7
H
A
A
F
F
G