JBL TempSet Unit L-U-W Manual Del Usuario página 9

Idiomas disponibles

JBL TempSet Unit L-U-W

*) Light bulbs not included.

Ready-to-use pre-assembled bulb holder kit for reliable and safe operation of JBL Reptil

Desert L-U-W Light and JBL Reptil Jungle L-U-W Light, as well as other metal halide lamps,

in terrariums.

With a high-quality VS electronic ballast.

Special red cable between the electronic ballast and the lamp socket with the approved

high-voltage resistant design, suited for the high ignition voltage required for metal halide

lamps.

Three-core lead (with a protective conductor) to the electronic ballast and a safety plug.

Quick coupling for easier assembly. All you need to do is drill a hole.

Sturdy joint for stepless adjustment of the angle of the lamp.

Microprocessor-controlled safety shut off after less than 20 minutes if the metal halide lamp

does not turn on.

End-of-life automatic shut off if the metal halide lamp is defective.

Automatic shut off of the ballast in case of overheating.

Exclusively suited for operation with metal halide lamps e.g. JBL L-U-W Light and other HID

lamps.

230 V, 50 Hz, E27, for metal halide lamps

Safety instructions:

Make sure that the operating voltage indicated on the name-plate agrees with the mains

voltage.

Always disconnect the power plug and allow the socket to cool off first before changing

L-U-W bulbs. Screw in the new bulb and then reconnect the power plug.

When screwing the L-U-W bulb in and out, always make sure to hold the socket with one

hand in order to prevent the cable from twisting.

Do not operate a TempSet L-U-W Unit with a damaged mains lead (2) or a damaged special

ignition cable (6).so

Damaged leads or special ignition cables may not be replaced by standard cables. Please

contact the manufacturer in the event of a damaged cable.

The lamp socket is a special socket and may not be replaced by a standard socket. Please

contact the manufacturer in the event of a damaged socket.

The electronic ballast of this JBL TempSet L-U-W Unit cannot be disassembled or repaired. If

damaged, it must be disposed of.

13_61875_00_0_V01-B.indd 5

Bulb Holder Kit * for metal halide lamps in terrariums

02.04.14 15:39

Tabla de Contenido