Introduction; Correct Operation - Evers THG Manual De Instrucciones

11
C O
ORRECT PERATION
The load lifting attachment is used for manual transport of single thin sheet metal plates. The
jaw capacity must be observed (Tab. 1).
Any different or exceeding use is considered incorrect. Evers GmbH will not accept
any liability for damage resulting from such use. The risk is
borne by the user/operating company alone.
The load lifting attachment is suitable for all loads of steel and other materials which withstand
the forces introduced via the load lifting attachment and which can be fully entered into the
mouth of the clamp.
The load capacity indicated on the unit is the maximum working load limit (WLL) that may be
attached.
Do not allow personnel to stay or pass under a suspended load.
A lifted or clamped load must not be left unattended or remain lifted or clamped for a longer
period of time.
The operator may start moving the load only after it has been attached correctly and all
persons are clear of the danger zone.
When attaching the load lifting attachment, the operator must ensure that neither the load
lifting attachment, the suspension (e.g. hook, shackle, etc.) nor the load pose a danger to
himself or other personnel.
Prior to operation of the load lifting attachment in special atmospheres (high humidity, salty,
caustic, alkaline) or handling hazardous goods (e.g. molten compounds, radioactive materials)
consult the manufacturer for advice.
The load lifting attachment may be used at ambient temperatures between –40° C and
+100° C. Consult the manufacturer in the case of extreme working conditions.
If longer sheets of metal or profiles are to be transported, we recommend that two or more
load lifting attachments be used.
Always transport the load slowly, carefully and close to the ground.
In the case of malfunctions, stop using the load lifting attachment immediately.
Heben • Sichern • Fördern • Verpacken
Evers GmbH • Graf-Zeppelin-Straße 10-12 • 46149 Oberhausen • Telefon (02 08) 99 475-0 • Telefax (02 08) 99 475-31 • E-Mail evers@eversgmbh.de • www.eversgmbh.de