CARE AND MAINTENANCE
• To eliminate the possibility of water damage to areas around the fountain, check for leaks and
excessive splashing after the initial setup of the fountain. It is highly recommended this fountain be
placed in an area where it cannot be damaged.
• Do not leave the fountain running for extended periods of time when no one is present to observe
the performance.
• Check the area around the fountain on a regular basis to ensure there is no leakage.
TROUBLESHOOTING
PROBLEM
Pump does not
operating.
Pump operates with
no water flow.
POSSIBLE CAUSE
1. Poor power connection.
2. Not enough water.
1. Not enough water.
2. Water supply tube kinked.
3. Water supply tube is
clogged.
CORRECTIVE ACTION
1. Check to make sure the pump is connected
to a power source.
2. Check the water level to ensure the pump
is completely submerged. Add water as
needed.
1. Check the water level to ensure the pump
is completely submerged. Add water as
needed.
2. Check the supply tube for any kinks or
folds and correct.
3. Disconnect the pump from the power
source. Disconnect the supply tube from
the pump outlet. Check for clogs or holes
and clean the tubing inside and outside if
necessary. Check for clogs and clean the
pump inlets and outlet if necessary. Place
the pump back into the water -- outlet side
up -- and then reconnect the pump to the
power source. Once the water begins to
flow from the pump, reconnect the supply
tubing to the pump outlet. Check for any
air trapped in the water supply tube which
may prevent the pump from working.
Lowes.com/gardentreasures
7