Assembling The Xplova Noza One - Xplova NOZA ONE Guia De Inicio Rapido

Assembly Instructions

Assembling the Xplova NOZA ONE

1. Open the packing box, remove the styrofoam top cover and take out the
installation tools and accessories from the accessory bag.
For front bottom tube
•
installation use:
Front bottom wrench
-
For the installation of the rear
•
bottom tube:
Rear bottom tube bolt x2
-
Rear bottom tube nut x2
-
Decorative bolt cover x2
-
Rear bottom wrench
-
For the installation of Flywheel/
•
cassette cover:
Flywheel/cassette cover
-
Flywheel/cassette cover
-
bolt x2
Flywheel/cassette cover bolt wrench
-
For the installation of control module:
•
Control module
-
Control module screw x2
-
2. Take out the NOZA ONE bike trainer main unit and front bottom tube from the
styrofoam cover and install according to the illustrations.
Xplova NOZA ONE
Bike trainer main unit
Diagram of completed front
bottom tube installation
Front bottom tube
TIP:
installing. When installation is done, make
sure the button goes through the locating
hole on the front leg.
EN-4
Press down the spring button when