Wiring Diagram - Baiduan 3779 Instrucciones

Rotate the bottom of the cover to the left and download it. The power cord goes
through the hole in the center of the bottom. Connect the power supply according to
the diagram. Secure the bottom of the bracket with a screw. The sensor must be
directed downwards. After finishing the installation, turn on the power and test.

WIRING DIAGRAM

TEST:
TIME or turn the knob counter-clockwise to clockwise to
minimum (-). LUX turn the wheel in the opposite direction
to clockwise to the maximum (sun).
Ø on the switch; The sensor and lamp lit not give any signal
to start. After heating of 30 seconds, the sensor can start
working. If the sensor receives infrared signal, the lamp
lights. If there is no more infrared signal, the load should
stop working within ± 3 sec 10sec after burning.
LUX clockwise or turn clockwise to minimum (moon). If the ambient light is
over 3 LUX, the sensor will not work and the lamp stops working. If the ambient
light is below 3 Lux (darkness), the sensor will operate. No infrared signal, the
sensor must stop working within 10 sec ± 3 sec.
Some problems and ways to solve them:
• The sensor does not work:
-Please Check if the connection of the power supply and the current is
correct.
-Please Check if the settings of working light correspond to the
ambient light.
• There is little sensitivity:
-Check If there is an obstacle in front of the detector that may affect
signal reception.
-Check The room temperature is not too high.
-check That is within the detection range.
-Please Check if the installation height corresponds to that required for
sensor installation height.
• The sensor does not turn off the light automatically:
-Please Check for continuous signal in the detection field.
-Please Check if the timer is set to the maximum position.
-Please Ensure that adequate power is indicated on the instructions.