UTC Fire & Security Interlogix TruVision TVD-TIR6-SR-P Guía De Bolsillo página 13

Installation
To install the camera:
1. Using the mounting bracket as a template,
place it level against the mounting surface and
mark the position of the mounting holes.
2. Following all local codes, drill and prepare the
mounting holes.
3. Route the camera's cable through one of the
four openings in the mounting bracket, and
then install the mounting bracket with the four
provided screws. If your mounting surface
requires it, use the provided wall anchors or
other appropriate fasteners.
4. While holding the camera in place, set the
camera shroud over the camera.
Note: If you are installing on a gang box or routing
the wires through the wall, connect a 75 ohm
coaxial video cable to the camera's video
cable, and connect a 12 VDC (TVD-TIR6-SR(-
P)) or 12 VDC/24 VAC (TVD-TIR6-MR/HR(-P))
power supply to the power cable.
5. Using the provided Hex wrench, lightly tighten
the three screws on the shroud. When lightly
tightened, the shroud holds the camera in place
and you can adjust the camera position.
11 EN