Samoa 366760 Guía De Servicio Técnico Y Recambio página 10

10
836 828 R. 10/12
Samoa Industrial, S.A. · Box 103 Alto Pumarín · 33211 Gijón - Asturias Spain · Tel.: +34 985 381 488 · Fax.: + 34 985 384 163
Calibration
Calibration mode
Display of current calibration factor
and restoring factory factor
calibration factor used. If no calibration has
ever been performed, or the factory setting
has been restored after previous calibrations,
the following display page will appear:
The word "Fact" abbreviation for "factory"
shows that the factory calibration factor is
being used
If, on the other hand, calibrations have been
made by the user, the display page will
appear showing the currently used calibration
factor ( in our example 0,998) .
The word "user" indicates a calibration factor
set by the user is being used...
The flow chart alongside shows the
To confirm the choice of calibration factor,
quickly press CAL while "User" or "Fact" are
displayed.
After the restart cycle, the meter uses the
calibration factor that has just been
confirmed.
w
hen the
u
old
By pressing the CAL key while the
appliance is in Standby, the display
page appears showing the current
switchover logic from one display
page to another. In this condition,
the Reset key permits switching
from User factor to Factory factor.
ATTENTION
f f
actory actor is confirmed
ser factor is deleted from the memory
,
the