Product Specifications - Enerpac PSCK8 Hoja De Instrucciones

CAUTION:
hydraulic hose. Avoid sharp bends
and kinks when routing hydraulic
hoses. Using a bent or kinked hose will cause
severe back-pressure. Sharp bends and kinks
will internally damage the hose leading to
premature hose failure.
Do not drop heavy objects on hose.
A sharp impact may cause internal
damage to hose wire strands.
Applying pressure to a damaged hose may
cause it to rupture.
IMPORTANT: Do not lift hydraulic
equipment by the hoses or swivel
couplers. Use the carrying handle or
other means of safe transport.
CAUTION:
equipment away from flames and
heat. Excessive heat will soften
packings and seals, resulting in fluid leaks.
Heat also weakens hose materials and
packings. For optimum performance do not
expose equipment to temperatures of 65°C
[150°F] or higher. Protect hoses and cylinders
from weld spatter.
DANGER:
pressurized hoses. Escaping oil
under pressure can penetrate the
skin, causing serious injury. If oil is injected
under the skin, see a doctor immediately.
3.O PRODUCT SPECIFICATIONS
Fluid Temperature Range
Viscosity Range
Hydraulic Oil
Flow Rate
Operating Pressure
Operating Range:
PSCK8
PSCK9
Dead Band:
PSCK8
PSCK9
Electrical Specifications:
Connection
Voltage/Amp Rating
Weight
Avoid damaging
Keep hydraulic
Do not handle

PRODUCT SPECIFICATIONS

–13° - +176°F [–25° - +80°C]
23,148 - 37.0 S.U.S. [5000 - 8.0 c.St]
HLP 23 ISO 3448– 1975
427 cu. in/min. [7,0 L/M] Max.
5000 psi [350 bar] {35 MPa}
1450–5000 psi [100–350 BAR] {10-35 MPa}
290–3045 psi [20–210 BAR] {2-21 MPa}
261–501 psi [18-35 BAR] {1,8-3,5 MPa}
87–218 psi [6–15 BAR] {0,6-1,5 MPa}
Socket Shape A 3–Pin+Ground Din 43650
24 VDC/2A
.50 Lb. [0,3 Kg]
WARNING: Only use hydraulic
cylinders in a coupled system. Never
use a cylinder with unconnected
couplers. If the cylinder becomes extremely
overloaded,
catastrophically causing severe personal
injury.
IMPORTANT: Hydraulic equipment
must only be serviced by a qualified
hydraulic technician. For repair
service, contact the Authorized ENERPAC
Service Center in your area. To protect your
warranty, use only ENERPAC oil.
WARNING:
worn or damaged parts by genuine
ENERPAC parts. Standard grade
parts will break causing personal injury and
property damage.
designed to fit properly and withstand high
loads.
WARNING: All live supply circuits
must be disconnected before wiring
the control.
CAUTION:
equipped systems should include
relief valves set slightly above
switch settings. Failure do do this could
result in personal injury and/or equipment
damage in the event of switch failure
115 VAC/2A 250 VAC/1A
2
components can
Immediately
ENERPAC parts
Pressure
fail
replace
are
switch