Noise/Vibration Information; Battery Packs/Batteries; Declaration Of Conformity - Wurth Master H 28-MA Instrucciones Para El Manejo

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
H 28 MA - Buch Seite 15 Montag, 12. Februar 2007 10:42 10
Disposal
Power tools, accessories and pack-
aging should be sorted for environ-
mental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household waste!
According to the European Directive 2002/96/EC
on waste electrical and electronic equipment and its
incorporation into national law, power tools that are
no longer suitable for use must be separately col-
lected and sent for recovery in an environmen-
tal-friendly manner.

Battery packs/batteries:

Do not dispose of battery packs /batteries into
household waste, water or fire. Battery packs /bat-
teries must be collected, recycled or disposed of in
an environmentally-friendly way.
Only for EC countries:
Defective or dead batteries must be recycled accord-
ing to the directive 91/157/EEC.
Warranty
For this Würth tool, we provide a warranty in
accordance with statutory /country-specific regula-
tions from the date of purchase (proof of purchase
by invoice or delivery note). Damage that has
occurred will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the warranty.
Claims can be recognised only when the tool is pre-
sented undisassembled to a Würth branch office or
a Würth field service employee.

Noise/Vibration Information

Measured
EN 60 745.
Typically the A-weighted noise levels of the machine
are: sound pressure level 94 dB (A); sound power
level 105 dB (A). Measurement uncertainty K = 3 dB.
Wear hearing protection!
Overall vibrational value (vector sum of three direc-
tions) determined according to EN 60 745:
Hammer drilling in concrete: Vibrational emission
value a
= 21 m/s
h
Chiselling: Vibrational emission value
a
= 15,5 m/s
h
The vibration emission level listed in these
instructions has been measured in accord-
ance with a standardized measuring proce-
dure in EN 60 745 and can be used for comparison
of one tool with another.
The vibration emission level will vary because of the
ways in which a power tool can be used and may
increase above the level given in these instructions.
This could lead to a significant underestimate of
exposure when the tool is used regularly in such a
way.
Note: To be accurate, an estimation of the level of
exposure to vibration experienced during a given
period of work should also take into account the
times when the tool is switched off and when it is run-
ning but not actually doing the job. This may signif-
icantly reduce the exposure level over the total work-
ing period.

Declaration of Conformity

We declare under our sole responsibility that this
product is in conformity with the following standards
or standardization documents:
EN 60745, EN 55014-1, EN 55014-2 according
to the provisions of the regulations 89/336/EEC,
98/37/EC.
07
Adolf Würth GmbH & Co. KG
P. Zürn
Subject to change without notice
values
determined
according
2
, uncertainty K = 1,5 m/s
2
, uncertainty K = 2,5 m/s
R. Bauer
to
2
2
.
15

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

H 28-mas

Tabla de contenido