Storing The Product - Ryobi RPP680 Manual De Utilización

STORING THE PRODUCT

See Figure 22.
idle unit indoors in a dry, well-ventilated area that is
inaccessible to children. Keep away from corrosive
agents such as garden chemicals and de-icing salts.
TRANSPORTING
Always place the scabbard on the saw bar when
transporting or storing the pole saw. The scabbard is
a snug fit and must be attached very carefully due to
the sharp teeth on the saw chain. This is best done
by grasping the scabbard at one end, in the center
portion of the scabbard, and carefully sliding it over
the chain as shown. Use caution to avoid the sharp
PROBLEM
Bar and chain running hot
and smoking.
Motor runs, but chain is
not rotating.
This marking indicates that this product should not be disposed with other household wastes throughout the EU. To prevent
possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote
the sustainable reuse of material resources. To return your used device, please use the return and collection systems
or contact the retailer where the product was purchased. They can take this product for environmental safe recycling.
English (Original instructions)
TROUBLESHOOTING
POSSIBLE CAUSE
condition
Bar lube reservoir empty.
and chain assembly.
DISPOSAL
teeth of the chain.
NOTE: The saw chain is very sharp. Always wear
protective gloves when handling the chain.
Tension chain. Refer to Chain Tension earlier in this
manual.
Retention chain. Refer to Chain Tension earlier in this
manual.
Refer to Replacing the Bar and Chain earlier in this
manual.
Inspect guide bar and chain
18
REMEDY