Soba BS310 Manual Del Usuario página 5

BS310 PRESSURE STEAM IRONING STATION
SETTING UP THE PRESSURE STEAM IRONING STATION
• Check that the socket has a protected earthing connection and that the current
and fuses (at least 10 A) correspond to specifications plate on the station.
• If the plug does not comply with your power supply, have it changed by a
qualified electrician.
• The electric safety of the appliance is only guaranteed when it is connected to a
correctly earthed connection according to official standards. If you are in doubt,
consult your electrician.
• The pressure steam ironing station should not be moved while it is in operation.
It is essential that it be set up on a surface that is not susceptible to high
temperatures.
STARTING UP
Tips/Safety Precautions
• This appliance is only intended for conventional domestic use. Every other use is
inappropriate and dangerous.
• Never touch the appliance with wet or damp hands.
• Never use the appliance in the bathroom.
• Never pull the plug out of the socket by tugging at the cable,
• Never expose the appliance to the elements e.g. rain, sun, ice etc.
• Do not let children use the ironing station; they cannot recognise the inherent
dangers of handling electrical devices.
• Never immerse the appliance in water.
• Never expose the appliance to frost.
• Leads and cables must not come into contact with the hot iron.
• Do not direct the steam towards people or animals (danger of scalding). Avoid
steam contact with unprotected skin.
• Switch off (On/Off switch) when not in use and unplug from the mains.
• Do not leave the appliance switched on unnecessarily.
• The iron must not be left unattended while it is connected to the mains supply.
• The plug must be removed from the socket before water is poured into the water
reservoir.
• If the supply cord is damaged, it must be replaced by a qualified electrician to
ensure safety.
• The filling cap is also a safety pressure device. Never replace it with any other
cap.
• The ironing station may give off steam and/or boiling water. ALWAYS wait for the
tank to cool down to room temperature before opening the filling cap. This will
take AT LEAST 15 MINUTES after normal operation.
3
INSTRUCTIONS