Installation And Use - arjo Enterprise ENT-ACC26 Instrucciones De Uso

Model ENT-ACC26 is designed to support ITU/ICU cardiac pressure transducers and associated
equipment. It is suitable for use on Arjo Enterprise® 5000, 8000 and 9000 series beds.
Refer to the bed instructions for use to confirm compatibility before using this accessory.
Remove the head end panel from the bed before using this accessory.
If a serious incident occurs in relation to this medical device, affecting the user, or the
patient then the user or patient should report the serious incident to the medical device
manufacturer or the distributor. In the European Union, the user should also report the
serious incident to the Competent Authority in the member state where they are located.

Installation and use

1. Locate the accessory at a suitable position along the top of the backrest, with the pole (1)
vertical and the mounting bracket (2) on the inside of the backrest frame (3).
2. Slide the clamp plate (4) down over the pole so that it rests on the mounting bracket.
3. Tighten the clamp screw (5) to grip the pole.
4. Attach pressure transducer apparatus to the pole as required.
5
4
WARNING
1
2
3
4
1
3
2
EN