Mellerware Rider Lithium Manual Del Usuario página 8

ASSEMBLING THE WALL BRACKET:
- The appliance has a wall bracket (N) which
must be fixed to the wall.
- Fix the wall bracket as you think appropriate,
using plugs, screws, and adhesive...
- Make sure that the bracket is firmly fixed; it
should be able to support twice the weight of
the appliance.
- Fit the appliance into the wall support.
CHARGING THE BATTERY
- Caution: A new battery is not fully charged and
must therefore be charged before the appli-
ance is used for the first time.
- Charge the battery at an atmospheric tempera-
ture of between 4 and 40ºC.
- Plug the charger (O) into the mains.
- A pilot light will come on to indicate that the
charger is ready to begin charging the battery.
- Approximately 3 to 4 hours are needed for a
complete charge of the battery. Never attempt
to over-charge the battery (although it is rec-
ommended that the first charge of the battery
be of 5 hours in duration).
- Connect the charger to the jack using the
socket on the appliance. The socket is located
at the back part of the appliance. (Fig 3)
- The pilot light will come on to indicate that the
charger is charging the battery.
- At the end of the time period specified above,
remove the battery from the charger.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is con-
nected to the charger.
CHANGE OF MOTORIZED BRUSH
- At the bottom of the brush you have to press
the button to unpin the brush. (Fig.10).
Choose the brush according to the needs of
aspiration:
- D-1 Bristles brush to use on carpets.
- D-2 Powder brush to use on hard floors.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product's packaging has been
removed.
- Before using this product for the first time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
- Connect the tube in the air intake and the brush
at the end of the extencion tube. (D)
- To disconnect the extension tube of the
vacuum cleaner, press the release button of
accessories (K) and pull out. (Fig.4)
USE:
- Turn the appliance on, by using the on/off
button. (L)
- Turn the appliance on, by using one of the
speed selection buttons.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The folloring accessory is designed to inster
into handy vacuum cleaner and extention tube.
(Fig. 5)
Accessory 2 in 1:
- A-1 Brush for furniture or textile.
- A-2 Lance.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
(L)
- Remove the battery from the appliance if you
are not intending to use the appliance during
an extended period.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.