Environment Protection; Declaration Of Conformity - Roney Power RPV 20.0-2Li Manual De Instrucciones

minutes and seek immediately medical attention.
• When battery is not in tool or charger, it should be kept away from metal objects such as nails, screws, keys
etc. to prevent short-circuit
• Do not use charger when damaged; take it to one of the officially registered Service Stations for a safety
check.
• Do not use battery when damaged; it should be replaced immediately.
• Do not disassemble charger or battery.
• Do not attempt to recharge non-rechargeable batteries with the charger.
• Normally when starting to charge the discharged battery, red and green LEDs of the battery charger are on.
When the battery is fully charged only green LED is on. If no LEDs are on while the charger is on, do not use
the battery and the charger and take them to the service center.
• When using your tool continuously, the batteries in your battery pack will become hot. You should let a hot
battery pack cool down for approximately 30 minutes before attempting to recharge.
• In case of long storage, store the battery in fully charged condition. WHEN CONNECTING NEW 3-PIN
PLUG (U.K. ONLY).
• Do not connect the blue (= neutral) or brown (= live) wire in the cord of the charger to the earth terminal of
the plug.
• If for any reason the old plug is cut off the cord of the charger, it must be disposed of safely and not left
unattended
To ensure longer service life and proper performance of the battery, take the following actions when you
start using new battery:
1. Use the new battery, without recharging it, till its complete discharge.
2. Then charge the battery for 1 hours.
3. Repeat abovementioned actions (1 and 2) 3-5 times to reach the nominal battery capacity.
MAINTENANCE
Make sure that the machine is not live when carrying out maintenance work on the motor. Regularly
clean the machine housing with a soft cloth, preferably after each use. Keep the ventilation slots free from dust
and dirt. If the dirt does not come off use a soft cloth moistened with soapy water. Never use solvents such as
petrol, alcohol, ammonia water, etc. These solvents may damage the plastic
parts.
The machine requires no additional lubrication.
If a fault occur, e.g. after wear of a part, please contact your local dealer's service.

ENVIRONMENT PROTECTION

In order to prevent the machine from damage during transport, it is delivered in a sturdy packaging. Most of
the packaging materials can be recycled. Take these materials to the appropriate recycling locations. Take
your unwanted machines to your local dealer. Here they will be disposed of in an environmentally safe way.
Li-ion batteries can be recycled. Deliver them to a disposal site for chemical waste so that they can be
recycled or disposed of in an environmentally friendly manner.
Discarded electric appliances are recyclable and should not be discarded in the domestic waste!
Please actively support us in conserving resources and protecting the environment by returning this
appliance to the collection centres (if available).
We declare under our sole responsibility that this product is in conformity with the following standards or
standardized documents: EN60745-1:2009+A11:2010; EN60745-2-1:2010; EN60745-2-2:2010; EN55014-
1:2006/A2:2011; EN55014-2:1997/A2:2008; in accordance with the regulations 2006/42/ЕEС, 2014/30/ЕEС.
NOISE/VIBRATION Measured in accordance with EN60745 the sound pressure level of this tool is <77dB(A)
and the sound power level is <88dB(A) (standard deviation: 3 dB), and the vibration is <2,5 m/s
mode).

DECLARATION OF CONFORMITY

2 (drilling
7