Inserting Batteries - LaserLiner AutoPoint-Laser 5 Manual De Instrucciones

1

Inserting batteries

Open the battery compartment (3) and insert batteries according
to the symbols. Be sure to pay attention to polarity.
8
7
9 10
13
2 Switch on
Assemble with connecting screw (11) AutoPoint-Laser 5 and magnetic base. Switch the unit on (5).
The laserdots will be projected.
Applications
3
(examples see P. 2)
A Aligning
B Horizontal levelling
!
If the device is positioned too much out of level (more than 3°), the laser will blink.
Position the device on a more level surface.
1 2
3
5
6 4
11
12 4
C Plumb line
D Height projection
AutoPoint-Laser 5
1 Laser emitting window
2 Rubber grip housing
3 Battery compartmentcover
4 1/4" nut for connection to camera tripod
5 ON / OFF-Switch
Pendulum lock
6 Self-leveling pendulum (inside)
7 Front beam calibration port (X-axis)
8 Side beam calibration port (Y-axix)
9 Magnets
10 5/8" nut for connection to constrution
tripod (mount from bottom).
11 Connecting screw AutoPoint-Laser 5
12 Screw mounting holes (accepts standard
drywall screws)
13 Slot for tightning belt
GB 07