Bosch SHE45C Manual De Uso Y Cuidado página 15

To Remove the Large Object Trap/Cylinder Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 34 and turn it
counterclockwise 1/4 turn.
FIGURE 34
3. Lift out the assembly as shown in Figure 35.
4. Carefully examine the assembly. If you ind debris in the
Large Object Trap, turn it upside-down and gently tap it
on a surface such as a countertop to dislodge and remove
the debris.
5. Flush the Cylinder Filter clean by holding it under running
water.
FIGURE 35
To Remove the Fine Filter:
1. Lift the Fine Filter from the dishwasher loor as shown in
Figure 36 and lush it clean by holding it under running
water.
2. Remove the Micro Filter and lush it clean by holding it
under running water.
All manuals and user guides at all-guides.com
To reinstall the ilter system:
FIGURE 36
FIGURE 37
Clean the Exterior door Panel
Colored Doors
Use only a soft cloth that is lightly dampened with soapy
water.
Stainless Steel Doors
Use a soft cloth with a non-abrasive cleaner (preferably a liquid
spray) made for cleaning stainless steel. For the best results,
apply the stainless steel cleaner to the cloth, then wipe the
surface.
Clean the door Gasket
Regularly clean the door gasket with a damp cloth to remove
food particles and other debris. Also clean the door seal, located
inside the dishwasher at the bottom of the door.
Winterizing your dishwasher
If your dishwasher will be unused for an extended period of
time in a location that experiences freezing temperatures (e.g.,
in a holiday home or through a vacation period), have your
dishwasher winterized by an authorized service center.
1. Return the Fine Filter to its installed position.
Fine Filter
2. Place the Large Object Trap/Cylinder Filter Assembly into
its installed position in the dishwasher loor.
4. Turn the ring handle clockwise 1/4 turn until it is locked.
The arrow on the ring handle and the arrow on the Fine
Filter should point to each other, as shown by the circle in
Figure 37.
6. Gently pull the ring handle to ensure that the assembly is
locked into place.
15