Publicidad
Idiomas disponibles
Idiomas disponibles
TECHNICAL DATA
Voltage range ......................................................... 7.2-24 V
Quick charge current ...................................................1,8 A
Maintaining charge .......................................................50 mA
Battery charging time
1,4 Ah ...................................................... approx 47 min
1,5 Ah ............................................................ approx 50 min
1,7 Ah ............................................................ approx 57 min
2,0 Ah ............................................................ approx 67 min
2,2 Ah ............................................................ approx 73 min
2,4 Ah ............................................................ approx 80 min
2,6 Ah ............................................................ approx 87 min
2,7 Ah ............................................................ approx 90 min
3,0 Ah .......................................................... approx 100 min
Weight according EPTA-Procedure 01/2014 .........500 g
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and instructions
may result in electric shock, fi re and/or serious injury.
Save all warnings and instructions for future reference.
SAFETY INSTRUCTIONS
Do not dispose of used battery packs in the household refuse
or by burning them. Milwaukee Distributors off er to retrieve old
batteries to protect our environment.
Do not store the battery pack together with metal objects (short
circuit risk).
Use only System PBS 3000 chargers for charging System
PBS 3000 battery packs. Do not use battery packs from other
systems.
The following battery packs can be charged with this charger:
voltage
battery
rating
(of storage battery)
7,2 V
B 7.2-range
≤ 1,4 Ah
9,6 V
B 9.6-range
≤ 1,4 Ah
12 V
B 12-range
≤ 1,2 Ah
14,4 V
B 14.4-range
≤ 1,4 Ah
18 V
B 18-range
≤ 1,4 Ah
24 V
B 24-range
≤ 1,4 Ah
9,6 V
M 9.6-range
≤ 2,2 Ah
12 V
M 12-range
≤ 2,2 Ah
14,4 V
M 14.4-range
≤ 2,2 Ah
18 V
M 18-range
≤ 1,4 Ah
24 V
M 24-range
≤ 1,4 Ah
Do not try to charge non-chargeable batteries with this charger.
No metal parts must be allowed to enter the battery section of
the charger (short circuit risk).
Never break open battery packs and chargers and store only in
dry rooms. Keep dry at all times.
The battery clamps of the charger are fed by the mains
supply. Do not touch the tool with conducting objects.
Never charge a damaged battery pack. Replace by a new one.
Before use check machine, cable, and plug for any damages
or material fatigue. Repairs should only be carried out by
authorised Service Agents.
This appliance is not intended to
be used or cleaned by persons
with reduced physical, sensory or
mental capabilities, or lack of
experience or knowledge, unless
they have been given instructions
concerning the safe use of the
appliance by a person legally
6
ENGLISH
responsible for their safety. They
should be supervised whilst using
the appliance. Children shall not
use, clean or play with this
appliance, which when not in use
should be secured out of their
reach.
Warning! To reduce the risk of fi re, personal injury, and
product damage due to a short circuit, never immerse your
tool, battery pack or charger in fl uid or al-low a fl uid to fl ow
inside them. Corrosive or conductive fl uids, such as
seawater, certain industrial chemicals, and bleach or bleach
containing products, etc., Can cause a short circuit.
SPECIFIED CONDITIONS OF USE
The quick charger can charge Milwaukee System PBS 3000
batteries from 7.2 V to 24 V.
Do not use this product in any other way as stated for normal
use.
MAINS CONNECTION
Connect only to single-phase a.c. current and only to the
system voltage indicated on the rating plate. It is also possible
to connect to sockets without an earthing contact as the design
conforms to safety class II.
No. of
BATTERIES
battery
Battery packs which have not been used for some time
cells
should be recharged before use.
6
General note concerning NiMH batteries:
8
The capacity of the battery is reduced when the temperature
10
falls below -10°C.
12
Long-term storage at temperatures higher than +40°C may
15
have negative eff ects on the capacity of the battery.
20
8
CHARACTERISTICS
10
After inserting the battery into the reception of the charger the
12
15
battery will automatically be charged (yellow control lamp is
20
illuminated continuously)
When a hot or cold battery pack is inserted into the charger
(fl ashing yellow lamp), charging will begin automatically once
the battery reaches the correct charging temperature
(5°C...45°C).
Standard charging time is approximately 47 minutes (1.4 Ah
battery). Charging time varies depending on the battery
temperature, charge needed and the type of battery pack
being charged.
As soon as charging is completed, the charger switches over
to "trickle" charge to maintain the full capacity (green control
lamp is illuminated continuously)
It is not necessary to remove the battery after charging. The
battery can be stored permanently in the charger without the
danger of being overcharged.
MAINTENANCE
If the supply cord of this appliance is damaged, it must only be
replaced by a repair shop appointed by the manufacturer,
because special purpose tools are required
Use only Milwaukee accessories and Milwaukee spare parts.
Should components need to be replaced which have not been
described, please contact one of our Milwaukee service agents
(see our list of guarantee/service addresses).
If needed, an exploded view of the tool can be ordered. Please
state the ten-digit No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
SYMBOLS
The battery clamps of the charger are fed by
mains supply. do not touch the tool with
conducting objects.
Please read the instructions carefully before
starting.
Do not burn used battery packs.
Do not dispose electric tools, batteries/
rechargeable batteries together with household
waste material.
Electric tools and batteries that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
Check with your local authority or retailer for
recycling advice and collection point.
Never charge a damaged battery pack.
Replace with a new one.
This tool is only suitable for indoor use. Never
expose tool to rain.
European Conformity Mark
British Confomity Mark
Regulatory Compliance Mark (RCM). Product
meets applicable regulatory requirements.
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH
7
Publicidad
