Monti BLASTER Manual Del Usuario página 10

EN Operating instructions
6. Fitting the Adaptor System & Bristle Blaster
Disconnect the battery from the unit before changing the belt or Adaptor System.
The machine must be switched off and the spindle at a standstill.
6.1 Positioning the accessory
See Figure 7.
a) Fasten Bristle Blaster
Adapter System (pay attention to rotation direction) and serrated lock washer and
screw. Ensure the Bristle Blaster
other.
Figure 7
b) For Bristle Blaster
c) Before plugging in to operate the tool, you must check that it is possible to actuate
the Safety Switch correctly and that the switch returns to the "OFF" position
when you release the pressure on the Safety Switch.
d) To start the tool, release the safety clip by pushing it backwards and push
the Safety Switch (Figure 8).
Figure 8
10
®
Belt correctly to the tool using the MontiPower
®
Belt adaptors are in an offset position from each
®
stainless steel belts, use only the stainless steel Accelerator Bar.
BRISTLE BLASTER
®
Belt
®
ELECTRIC DOUBLE
®