ARIETE RoboMax Metal 1786 Manual De Instrucciones página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 26
EN
- NEVER ADD LIQUIDS TO MIX THE CHOPPED FOODS TOGETHER.
- If it is necessary to add foods during appliance operation, use the opening in the lid (R). Push the
foods down with the pusher (I) on its own or together with the small pusher (L) (Fig. 7).
WARNING: Never insert foods by hand. Always use the pusher.
- To stop the appliance, turn the dial (A) to "0".
Slicing
WARNING: The blades are sharp; handle with care.
-
Fit the required blade, the slicing blade (P), julienne blade (O) or chip blade (Q) into the blade
disc (N) so that the hole in the blade is in the centre of the disc (Fig. 8).
-
Fit the blade disc (N) onto the blade support (F), gripping it by the slots, with the blade facing
upwards (Fig. 9).
-
Fit the lid (R) over the bowl (S) and proceed as described in the section "Chopping, mixing or
whisking".
INSTRUCTIONS FOR BLENDER USE
WARNING: Before cleaning the appliance and installing or removing attachments, make sure that it
is not connected to the mains power and that the operating dial (A) is set to "0".
- Fit the blender (C) onto the power base (B) and turn it clockwise so that it clicks into place when
the tabs on the blender fit into the relevant slots on the power base (Fig. 10).
WARNING: The blades are very sharp; handle with care.
- Fit the lid (D) onto the blender (C), bringing the tabs on the blender into line with the slots in the
lid and lock it into place by turning it clockwise (Fig. 11).
- Insert the previously prepared foods through the hole in the lid (D), without exceeding the maxi-
mum level marked on the blender (C), then insert the filler cap (E) into the lid (D), pressing it down
gently and turning it anticlockwise to lock it in place (Fig. 12).
- Switch on the appliance, selecting the blade rotation speed with the operating dial (A). The appli-
ance has two speeds: minimum «1» and maximum «2».
It is also possible to select pulse operation by turning the dial (A) anticlockwise to «P». For the
best use of this function, only turn the dial for a very short time (2-3 sec.).
WARNING: Never operate the appliance for more than 30 seconds at a time. Wait at least 2 minutes
before operating it again.
WARNING: For softer fruit and vegetables (e.g., bananas), start at slow speed and then increase the
speed as required. For firmer fruit or vegetables (e.g., carrots), use the maximum speed.
- For a smoother result, switch off the appliance, unplug it from the mains power, remove the lid
(D) and use a spatula to move the foods away from the sides of the blender (C) and towards the
centre.
WARNING: To prevent accidents or damage to the appliance, always keep hands and cooking
utensils well away from moving blades or cutting discs.
WARNING: Never remove foods from the sides of the blender while the appliance is operating.
- Repeat the above steps for processing other foods.
WARNING: Never place more than 300g of firm fruit or vegetables into the blender at any one
time.
- 10 -

Publicidad

Tabla de contenido
loading

Tabla de contenido