XPR Access MINI-SA 2 Instrucciones De Montaje página 4

PROGRAMMING FLOWCHART
Enroll Master and Delete Card
1. Turn OFF the power supply
2. Push dip switch no.1 in position OFF.
3. Turn ON the power supply. All three LEDs will blink continuously.
4. Enter Master Card. Red and Yellow LED will blink.
5. Enter Delete Card. Red LED will blink.
6. Turn OFF the power supply.
7. Put the dip switch in position ON.
NOTE: Changing Master and Delete Card is done with the same procedure. Old Master and Delete Card are deleted automatically.
Enroll a User
• Cards can be programmed individually or as a block of sequential cards.
• For each User, 2 cards are being programmed: 1 User Card and 1 Shadow Card.
• The User Card is issued to the User and the Shadow Card is kept on safe place.
• If the User Card is lost or stolen, the Shadow Card will be used to delete the corresponding User Card.
NOTE: Shadow card can be issued for 1 user or for group of users. In both cases, write the name of the user on the shadow card
and keep all of the shadow cards on safe place.
NOTE: If more than one user is associated to same shadow card, deleting with that shadow card will result with deletion of all the
Users associated to that shadow card.
NOTE: If a shadow card needs to be changed, just enroll the same User with different Shadow card.
Enroll block of user cards
NOTE: The block of User cards can be maximum 100 Cards.
www.xprgroup.com
Example: Enroll 2 Users
Present Master Card
Present Shadow Card
Present User Card
Present Master Card
Present Master Card
Present Shadow Card
Present User Card
Present Master Card
Example: Enroll 100 cards
Present Master Card
Present Shadow Card
Present the beginning card of the
block 3 times (ex. 180 20001)
Present the ending card of the block
3 times (ex. 180 20100)
Present Master Card
4