INSTALLATION DOCUMENTATION and PERIODIC EXAMINATION
The anchor devices should be installed only by competent persons or competent organizations. The installation should be verified
appropriately, e.g. by calculation or testing.
If the marking of the anchor device is not accessible after installation, additional marking near the anchor device is recommended on the
suitability of base materials, structural anchor, or fixing element if applicable, by taking into account the loads recorded on the anchor device
during the dynamic strength and integrity tests.
For type B anchor device, it is imperative that the anchor device be stable. To ensure the stability of the anchor device refer to operating
instructions of the device.
GUIDANCE ON PERIODIC EXAMINATION PROCEDURE OF ANCHOR DEVICES
Availability of installation documentation
Examination of installation documentation and previous inspections
Identification of the manufacturer
Visual inpection of the device
Examination of corrosion on metallic part (if present)
Examination of integrity of textile part (if present)
Examination of wear and tear of the device and its parts
Examination of presence of deformation or anomalies
Examination of absence of sharpe edges or dangerous situations for the device
Examination of fixing and mounting structure
Examination of resistance according to manufacturer's information of means of tests
Examination of marking (readability and integrity)
Right filling of periodic examination documentation
The procedure for periodic inspection must be satisfied in all its points. Otherwise you have to proceed with the replacement of the
anchoring device.
INSTALLATION DOCUMENTATION
INSTALLATION/ EXAMINATION INFORMATION
TRADEMARK:
MODEL CODE OF THE DEVICE:
TYPE OF ANCHOR DEVICE:
BATCH NUMBER:
ADDRESS OF INSTALLATION:
LOCATION OF INSTALLATION:
NAME OF THE PERSON IN CHARGE OF INSTALLATION:
NAME OF THE INSTALLATION COMPANY:
ADDRESS OF THE INSTALLATION COMPANY:
FIXING ELEMENTS
SCHEMATIC INSTALLATION PLAN (add relevant user information, such as where the anchor points are located, relevant in case of snow):
DECLARATIONS GIVEN BY THE INSTALLER:
Anchor device was installed in accordance with the manufacturer's instructions
Anchor device was carried out according to the plan
Anchor device was fixed as specified (e.g. number of bolts, correct materials, correct position/location)
Anchor device was fixed to the specified substrate
Anchor device was commissioned in accordance with the manufacturer's information
Anchor device was supplied with photographic information/documentation, especially where fixings and
the underlying substrate are no longer visible after completing the installation
COMMENTS AND NOTES:
This plan should be affixed to the building so as to be visible or available for everybody (e.g. at the roof access point). After installation,
copies of the installation documentation should be handed over to the user. This documentation should be kept in the building for the
purpose of subsequent examinations of the anchor device.
B.P. 140 - ZAC de La Peyrolière
84405 APT CEDEX - FRANCE
MANUFACTURERS:
PRODUCTS:
MODELS CODES AND BATCH NUMBERS:
PERMISSIBLE TENSILE AND TRANSVERSE FORCES:
TRAxx Anchorage device
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
MANUFACTURER:
DELTA PLUS GROUP
□
YES
□
YES
□
YES
□
YES
□
YES
□
YES
SIGNATURES :
UPDATE : 12.02.2016
EN
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
□
NO
Page 62/62