Oehlbach BTT 5000 Manual Del Usuario página 13

Operation
Connection instructions:
1. Either plug the USB connector of the BTT 5000 into a USB
port on your output device (e.g. TV, AV receiver, etc.) or use
the supplied mains adapter for the power supply.
2. Connect the supplied 3.5mm jack cable to a corresponding
output on your device (e.g. smartphone, tablet, TV, amplifier,
etc.). You can also use the supplied adapter here, for
example, to utilise a stereo RCA output.
Connecting a Bluetooth device:
1. Set the Bluetooth receiving device to its pairing mode.
2. When the device is in its pairing mode the BTT 5000 will
automatically attempt to establish a connection.
3. When a connection has been established successfully the
LED on the BTT 5000 will illuminate continuously.
Connecting a second Bluetooth device:
1. Set the second Bluetooth receiving device to its pairing
mode.
2. Press the pairing button on the BTT 5000 for 1 to 2 seconds
until its pairing mode is activated (LED flashes).
3. Under certain circumstances, you may need to switch off the
first connected device in order to connect the second device.
When a connection has been established successfully for
the second device, you can switch the first device back on
again. This should then automatically reconnect to the BTT
5000 after a short time, meaning that the two devices are
simultaneously connected to the BTT 5000.
BTT 5000
13