Descargar Imprimir esta página

Publicidad

Enlaces rápidos

5300 Service Module Installation
Installation De Module De Service 5300
Instalación Del Módulo De Servicio 5300
©
2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
R
Page 1 of 6
939504652 Rev B

Publicidad

loading

Resumen de contenidos para Turnstone 5300

  • Página 1 5300 Service Module Installation Installation De Module De Service 5300 Instalación Del Módulo De Servicio 5300 © 2001 Steelcase Inc. Grand Rapids, MI 49501 U.S.A. Page 1 of 6 Printed in U.S.A. 939504652 Rev B...
  • Página 2 Level parent unit (Desk, Credenza or Table). PARENT UNIT UNITÉ DE PARENT Remove inner back panel UNIDAD DEL PADRE or tackboard by tipping outward at top and lifting up. NOTE: Reverse Steps 2 & 3 if your tackboard is shipped separate.
  • Página 3 Attach sides to outer #8-15 x 1/2” Screw back panel, then re-install inner vis de #8-15 x de 1/2” back panel or tackboard. tornillo de #8-15 x de 1/2” END PANEL LH MAIN GAUCHE DE PANNEAU D'EXTRÉMITÉ Turn unit upside down LH DEL PANEL DEL EXTREMO and attach dust covers and doors.
  • Página 4 Locate pilot holes measured 15” down from top of end panels. Insert screws halfway in on both end panels. 1 5 " Install shelf on screws and tighten. Remove foam shipping block and install center brace. Be sure pivot pins are in tracks on center brace.
  • Página 5 El clip unía cualquier módulo de servicio Attach clip to service module with #8-1/2 Pan Hd screws and a las tapas, a las tablasy a Turnstone del attach clip to edge of desk top with #6-3/4 Rh Ph screws. credenza de la serie 5300 seriestops. El perforarrequerido.
  • Página 6 Door Adjustment Up or down adjustment Slightly rotate pivot pin on each side of binder bin door to raise or lower door, being careful not to use excessive force. There should be approximately 1/16” gap between top of door and dust cover. Rotate pivot pin forward to raise, backward to lower.