Extremis Sol+Luna Manual De Instrucciones página 16

Warnings – Assembly text instructions – Maintenance
English
WARNINGS
General
• Do not use any sharp tools to open the
packaging.
• We strongly advise against using power tools.
• Do not put out cigarettes on the fabric.
• Not grafitti proof.
• To avoid danger of suffocation, keep plastic bags
away from babies and children.
• Colours can differ over years and from batch to
batch.
Product
• Store the parasol when not in use for a long time
as follows, vertically, completely dry and in a dry
environment.
• If you are not using the parasol, use the cover to
avoid the parasol from getting dirty.
• When not in use, or with strong wind, minimuze
the length of the arm.
• Only move the parasol up and down by holding
the handles, always secure firmly.
High-tech polyester
• Shake or brush off loose dirt immediately.
• Do not use any aggressive detergents as they will
remove the protective coating of the fabric.
• We strongly advise you not to use a high-pressure
hose for cleaning.
Stainless steel
• Very good UV colour fastness.
• Flame retarding: NEN-EN13501-1 A1 - Class A1
products will not contribute to fire in any stage,
including fully developed fire. For this reason,
they are assumed to be capable of satisfying all
requirements of all lower classes as well.
• Watch out, stainless steel isn't entirely rustproof!
Be sure to avoid contact with iron objects. If it
does show signs of rust, clean with rust remover
as quickly as possible.
Anodised aluminium
• Do not use abrasive scouring powders or
scourers as they will scratch the surface.
• Colour can fade to some extent when exposed to
UV.
• Flame retarding - NEN-EN13501-1 A2-sl -
16
Satisfying the same criteria as Class B for the
SBI-test according to EN13823. In addition,
under conditions of a fully developed fire these
products will nog significantly contribute to the
fire load and fire growth.
• Dark colors can get very hot in sunny weather.
LED light
• This product meets the requirements of European
Directives 2006/95/EC and 2004/108/EC.
• 100-240 V ~50/60 Hz
• The supplied plug (part of SD) a a Europlug (Type
E). In countries where this plugis not used, please
provide a suitable plug yourself.
ASSEMBLY INSTRUCTIONS
Flat parasol - p6
1. The parasol pole is attached to the Sol+Luna
lounger with a clamp system. To release it, turn
the handle at the top of the tube anticlockwise (to
the unlocked position).
2. Now you can insert the parasol pole into one of
the four holes in the lounger.
3. Fasten the pole into the lounger by turning the
handle clockwise (to the locked position).
4. Slide the parasol and sliding system over the
pole. Please note: make sure the parasol is facing
upwards, as in the diagram.
5. Remove the screw indicated in the diagram.
6. Attach the handle to the underside of the sliding
system.
7. Choose the desired parasol height by tightening/
loosening the rotary knob. You can now slide the
parasol up or down.
8. You can also extend and tilt the parasol. Always
tighten it afterwards using the handle.
Parasol with led - p10
1. The parasol pole is attached to the Sol+Luna
lounger with a clamp system. To release it, turn
the handle at the top of the tube anticlockwise (to
the unlocked position).
2. Now you can insert the parasol pole into one of
the four holes in the lounger.
3. Fasten the pole into the lounger by turning the
hand clockwise (to the locked position).
4. Slide the parasol and sliding system over the
pole. Please note: make sure the parasol is facing
upwards, as in the diagram.
5. Remove the screw indicated in the diagram.