Installing The Electronic Smartdoor; Preparing Your Electronic Smartdoor - Petsafe Electronic SmartDoor Guía Para El Uso

Installing the Electronic SmartDoor

See accompanying installation template for intallation instructions.
__________________________________________________________________________________________

Preparing Your Electronic SmartDoor

Step 1: Install the 4 D-Cell Batteries
1. With a Phillips screwdriver, remove the two Battery Box
Cover screws.
2. Remove the Battery Box Cover.
3. Refer to the inside of the Battery Box Cover for the
proper orientation of the four D-cell batteries.
4. The fi rst set of two D-cell batteries should be installed,
in the bottom of the Battery Box, with the positive
connection towards the right. The second set of two
D-cell batteries should be installed with the positive
connection towards the left.
5. When the batteries are placed in the Electronic
SmartDoor's battery box, the red LED will illuminate for
2 seconds and the fl ap will move to the locked position. If
the fl ap is in the locked position, nothing will happen.
Note: The door must be in the vertical position for the fl ap to
center properly and operate correctly.
6. Replace the Battery Box Cover and re-install the 2
Battery Box Cover screws.
Step 2: Install the Range Knob
Fit the Range Knob over the Range Knob shaft and
press it fi rmly into place.
Note: The blade in the provided Range Knob must align with
the slot in the Range Knob shaft.
Step 3: Install the PetSafe
1. Place the PetSafe RFA-67 battery into the front of the
SmartKey.
2. Using a coin, rotate one-quarter turn clockwise to secure
the PetSafe RFA-67 battery.
SmartKey Low Battery Condition
The SmartKey transmitter is equipped with a red LED inside
the housing. Should the LED begin to fl ash, the PetSafe RFA-67 battery is getting low on charge and
should be replaced as soon as possible.
® RFA-67 Battery in the SmartKey
www.petsafe.net
™
™
5