Sony HT-CT550W Manual De Instrucciones página 14

Installing the speaker on a
wall
You can install the speaker on the wall.
Notes
• Use screws that are suitable for the wall material and
strength. As a plaster board wall is especially fragile,
attach the screws securely to a wall beam. Install the
speaker on a vertical and flat reinforced area of the
wall.
• Be sure to subcontract the installation to Sony dealers
or licensed contractors and pay special attention to
safety during the installation.
• Sony is not responsible for accidents or damage
caused by improper installation, insufficient wall
strength, improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that are
suitable for the holes on the back of the
speaker. See the illustrations below.
more than 25 mm (1 inch)
5 mm
(1/5 inches)
10 mm
(2/5 inches)
Hole on the back of the speaker
2
Fasten the screws to the wall. The
screws should protrude 6 to 7 mm
(approx. 1/4 inches).
6 to 7 mm
(approx. 1/4 inches)
14
US
4 mm (1/6 inches)
265 mm
(10 2/5 inches)
3
Hang the speaker onto the screws.
Align the holes on the back of the speaker to
the screws, then hang the speaker onto the
two screws.