BaByliss PRO Latherfx FXHLM Manual Del Usuario página 4

control cap adjustment switch
NOTE: Slide adjustment switch as far as possible, it may not go all the way to
the gel position
gel nozzle gel position
gel release button
Properly installed gel unit
STEP 4
To use with gel:
- Depress control cap firmly and slide the
adjustment switch as far as possible toward the
gel side. This step holds the control cap down in
the gel position
To use with lather:
- Move adjustment switch into lather position
STEP 5
Insert cap with can attached into base and turn
to lock
lather nozzle lather release control cap
lather position
Properly installed lather unit
IMPORTANT
OVERSIZED CANS MAY NOT FIT INTO THE PROTECTIVE CYLINDER.
THE CONTROL CAP WILL WORK ON THE LATHER CAN WITHOUT THE
CAUTION: Do not block dispenser nozzle with hand, as hot steam may be
emitted during use or when the can of gel is low. Replace can when gel is
running low. Hold hand to side and under, not in front of dispenser.
Once you have shaved, turn the unit off, by pressing the OFF button.
BE SURE TO UNPLUG THE UNIT WHEN NOT IN USE.
USING LATHER
• When using shaving lather, be sure to use the lather nozzle provided with the
unit. This is the nozzle without the button on it. For help on how to use the
FXHLM refer to the section titled "Very Important Setup Instructions" in this
instruction booklet and insert shaving lather can as described.
• Press the power "ON" button on the top of the machine.
• After a few minutes, the Ready indicator light will stop blinking and stay on.
• Press down on the top of the machine to dispense heated lather into the
palm of your hand.
• Spread lather over your face as usual for a comfortable hot shave.
USING GEL
• When using shaving gel, be sure to use the gel nozzle provided with the unit.
This nozzle has a button to control the gel flow. For help on how to use the
FXHLM refer to the section titled "Very Important Setup Instructions" in this
instruction booklet and insert shaving gel can as described.
• Push down on the control cap. At the same time, slide the adjustment switch
CYLINDER.