Troubleshooting Guide; User Maintenance - BaByliss PRO Latherfx FXHLM Manual Del Usuario

until the top is locked in place; this will release gel into the machine to be
heated.
• Press the power "ON" button on the top of the machine.
• After a few minutes, the Ready indicator light will stop blinking and stay on.
• Press the gel release button on the nozzle to release heated gel into the
palm of your hand.
• Spread gel over your face as usual for a comfortable hot shave.
TO REMOVE CAN
When can is empty or when using for travel, it will be necessary to remove the
can from the machine.
1. Be sure the machine is unplugged from the outlet.
2. With one hand holding the can, remove the machine and can from the
protective cylinder. Then depress the locking tab with the other hand and
pull the control cap off.
3. Clean the machine with a damp cloth. DO NOT IMMERSE THE MACHINE
IN WATER!

TROUBLESHOOTING GUIDE

PROBLEM: Gel or lather is too runny.
SOLUTION: Adjust temperature control dial to a lower setting.
PROBLEM: Unit fails to heat.
SOLUTION: Make sure the unit is plugged in and turned on. Top red light
should be blinking. After 1 to 3 minutes or until the red light glows solid, the
unit is ready to dispense hot gel/lather.
PROBLEM: Unit will not dispense lather.
SOLUTION: Unit is not properly mounted to the can. Remove unit from can,
then reattach, making sure that the unit is securely attached to the top of can
or check the lather can is using the lather nozzle and perfectly locked.
PROBLEM: Unit will not dispense gel.
SOLUTION: Unit is not properly mounted to the can. Remove unit from can,
then reattach, making sure that the unit is securely attached to the top of can
or check the gel can is using the gel nozzle and is perfectly locked.
PROBLEM: The gel/lather is too hot or too much steam is emitted.
SOLUTION: Adjust temperature control dial to lower setting, or replace can if
it has a low amount of gel/lather.

USER MAINTENANCE

Your Gel/Lather Heating System is virtually maintenance free. No lubrication is
needed. Keep all vents and openings clear of dirt and dust. If cleaning becomes
necessary, disconnect the unit from the power source, allow to cool and wipe
exterior with a cloth. If any abnormal condition occurs, unplug the unit, allow it
to cool and return it for repair to an authorized service representative only. No
repairs should be attempted by the consumer.
CAUTION
NEVER allow the power supply cord to be pulled, twisted or severely bent.
Never wrap the cord tightly around the appliance. Damage will occur at the
high flex point of entry into the appliance, causing it to rupture and short
circuit. Inspect the cord frequently for damage. Stop use immediately if
damage is visible or if unit stops or operates intermittently.
STORAGE
When not in use, your appliance is easy to store. Allow appliance to cool, then
simply store out of reach of children in a safe, dry location. Do not jerk or strain
cord at plug connections. Do not wrap the line cord around the appliance.
Allow the cord to hang or lie loose and straight at the point of entry into the
appliance.