12 | English
Only use the dust extractor if you can fully evaluate all func-
tions and carry them out without restrictions, or if you have
received corresponding instructions.
Rotational Airflow
The bagless filter system removes the need to use dust bags.
Dirt is collected on the inside wall of the container.
Product Features
The numbering of the product features refers to the repres-
entation of the vacuum cleaner on the graphic pages.
(1) Coarse dirt filter
(2) Release button for dust container
(3) On/off button
a)
(4) Rechargeable battery
(5) Motor housing
(6) Dust container
(7) Emptying flap release button
(8) Emptying flap
(9) Extension tube
(10) Floor nozzle
(11) Battery holder
a)
(12) Battery release button
(13) Crevice nozzle
(14) Flexible extension tube
(15) Filter grips
(16) Filter
(17) Rotational airflow unit with filter (16)
(18) Filter locking tab
a)
(19) Wall bracket
a) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
Technical data
Cordless dry vacuum cleaner
Article number
Container volume (gross)
A)
Max. vacuum
A)
Max. flow rate
Weight according to
EPTA-Procedure 01:2014
Recommended ambient
temperature during charging
Permitted ambient temperature
B)
during operation
and during
storage
Compatible rechargeable
batteries
1 609 92A 6TL | (07.09.2021)
Cordless dry vacuum cleaner
Recommended rechargeable
batteries
Recommended chargers
A) Depends on battery in use
B) Limited performance at temperatures < 0 °C
Rechargeable battery
Charging the battery
Use only the chargers listed in the technical data. Only
u
these chargers are matched to the lithium-ion battery of
your dust extractor.
Note: The battery is supplied partially charged. To ensure
full battery capacity, fully charge the battery in the charger
before using your power tool for the first time.
The lithium-ion battery can be charged at any time without
reducing its service life. Interrupting the charging process
does not damage the battery.
The lithium-ion battery is protected against deep discharge
by the "Electronic Cell Protection (ECP)". A protective circuit
switches the cordless dust extractor off when the battery is
drained.
Do not continue to press the on/off button after the
u
dust extractor has automatically switched itself off.
This can damage the battery.
Inserting the Battery
Push the charged battery into the battery holder until it
clicks into place.
Removing the Battery
To remove the rechargeable battery, press the battery re-
lease button and pull the battery out. Do not use force to do
GAS 18V-1
this.
The rechargeable battery has two locking levels to prevent
3 601 JC6 2..
the battery from falling out if the battery release button is
l
0.7
pressed unintentionally. The rechargeable battery is held in
kPa
6
place by a spring when fitted in the dust extractor.
l/s
10
Battery charge indicator
A)
kg
1.7–2.3
The green LEDs on the battery charge indicator indicate the
state of charge of the rechargeable battery. For safety reas-
°C
0 to +35
ons, it is only possible to check the state of charge when the
dust extractor is not in operation.
°C
–20 to +50
Press the button for the battery charge indicator
show the state of charge. This is also possible when the re-
chargeable battery is removed.
GBA 18V...
If no LED lights up after pressing the button for the battery
ProCORE18V...
charge indicator, then the rechargeable battery is defective
and must be replaced.
GAS 18V-1
GBA 18V...
ProCORE18V...
≤ 8 Ah
GAL 18...
GAX 18...
GAL 36...
or
to
Bosch Power Tools