AGV GPTECH Instrucciones Para El Propietario página 17

5) ACCESSORIES
A racing kit is available for the GP-Tech, made up of perforated visor and safety screws for extra secure fas-
tening of the visor: this kit drastically reduces the possibility of the visor coming away from the helmet in the
event of an accident.
The use of the visor racing kit does not affect the opening and closing of the visor.
1 - Perforated visor
NB The use of the racing kit is only allowed on the race track or on roads which are not open to the
public.
1
2
4
2 - Safety screws (1 pair for fastening + 1 spare pair)
5.1) Visor Racing Kit installation/removal
We recommend that you carry out the following opera-
tions while resting the helmet on a flat surface.
To install the visor racing kit, remove the original visor following the in-
structions in the "Visor Removal/Installation" paragraph. Then install
the perforated visor following the instructions below. Starting from one
side of the helmet, with the visor completely raised,
connection of the visor into its housing on the movement base (1), then
insert the lower connection of the visor into the visor stop (pulling the
3
To remove the visor racing kit, inscrew the two safety screws
and remove the perforated visor as described above in the "Vi-
sor Removal/Installation" paragraph (4).
insert the upper
cursor downwards if necessary)
(2). Repeat the operation on the
other side. Screw the safety
screws into their housings on
both sides of the movement base
(3). Lower the visor and check
that it works properly.
17