Cequent Performance Products 24961 Instrucciones De Instalación página 4

Lower exhaust - Drop muffler by removing (2) rubber isolator hangers
off of hanger rods. Spraying a lubricant or soapy water on the metal
hanger rod and the rubber isolator eases removal.
Insert fasteners - Using reverse fishwire procedure insert 7/16"
Carriage Bolts and special washers into vehicle frame as shown above.
Do this on both sides of vehicle before raising hitch into place.
©2017 Cequent™ Performance Products, Inc. - Printed in Mexico
(If necessary) Trim heat shield - Remove nuts for muffler heat shield
with 10mm socket. Measure 1" rearward from middle attachment hole on
heat shield, mark a perpendicular line and remove rear portion of the heat
shield. See Figure 2. Reinstall heat shield with two remaining attachment
holes.
Cut Heat Shield in
half at this line.
Vehicle
Forward
Raise hitch into position - Carefully raise hitch into place over muffler
and up around bolts installed in Step 1 above, being careful not to push
bolts back up into frame, leaving fishwires attached. Install 7/16" Conical
Washers and 7/16" Nuts on to bolts securely without tightening to hold
hitch in place.
Sheet 4 of 15 24961NP
1"
3-14-17 Rev. A