IMPPUMPS SAN ECO 15/15 Instalación Y Funcionamiento página 12

7.3 Setting the timer (see figure 7)
Set the current time by turning the setting dial (1) in the direction of the-
arrow until the current time matches the marking (2). Pull out the
tabs (3) for the times that the pump should run.Set the function se-
lection switch (4):
ON = pump runs continuously,
OFF = pump is off,
(TIMER) = pump runs according to the program that is
selected by the tabs.
7.4 Setting the control thermostat
Select the desired temperature using the selector knob placed on
the motor housing.
8. Maintenance / Disassembly
Pumps are subject to wear. If the pump is blocked or grinding noises
are audible, check the pump and replace it if necessary. Procedure:
- Disconnect pump from the mains.
- Close the connection lines.
- Loosen the union nut and remove the motor (Residual
water may leak out of the rotor cavity. Prevent the electri-
cal connection to the pump from getting wet.).
9. Troubleshooting
Work on electrical parts may only be performed by
authorized specialists.
-12-