Publicidad
Idiomas disponibles
Idiomas disponibles
AGITATOR
OVERLOAD
PROTECTOR
The agitator has built-in protection
against motor damage should the
agitator jam. If the agitator slows down
or stops, the agitator overload protector
shuts off the agitator
motors. The vacuum
cleaner suction motor will continue to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press OVERLOAD PROTECTOR RESET.
NOTE: Once the agitator motor shuts
down, clear jam from agitator and
wait a minimum of 20 seconds before
resetting overload protector.
If the problem
persists, have the vacuum
cleaner
serviced
by a Sears or other
qualified
technician.
Always
follow
all safety
precautions
when performing
maintenance
to the vacuum
cleaner.
_WARNiNG
Electrical Shock And Personal injury Hazard
Disconnectelectrical supply before servicing or cleaning the vacuum cleaner. Failure to do
so could result in electrical shock or personal injury from vacuum cleaner suddenly
starting.
CLEANING
EXTERIOR
AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. To clean exterior, or to reduce static elec-
tricity and dust build-up, wipe outer surface
of vacuum cleaner and attachments. Use a
clean, soft cloth that has been dipped in a
solution of mild liquid detergent and water,
then wrung dry. Wipe dry after cleaning.
Wash crevice
tool and dusting
brush in
warm soapy water, rinse and air dry.
Do not
clean in dishwasher.
CAUTION
Do not use attachments if they are wet.
Attachments used in dirty areas, such
as under a refrigerator,
should not be
used on other surfaces
until they are
washed. They could leave marks.
=14 =
Publicidad
