Overload Protector - Sears Kenmore Elite 116.31150 Manual De Uso

Ocultar thumbs Ver también para Kenmore Elite 116.31150:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AGITATOR
OVERLOAD
PROTECTOR
The agitator has built-in protection
against motor damage should the
agitator jam. If the agitator slows down
or stops, the agitator overload protector
shutsoff the agitator motors. The vacuum
cleaner suction motor will continue to run.
To correct problem: Turn off and unplug
vacuum cleaner, remove obstruction, then
press OVERLOAD PROTECTOR RESET.
NOTE: Once the agitator
motor shuts
down, clear jam from agitator and
wait a minimum of 20 seconds before
resetting overload protector.
If the problem
persists,
have the vacuum
cleaner
serviced
by a Sears or other
qualified
technician.
Always follow all safety precautions when performing maintenance to the vacuum cleaner.
WARNING
Electrical Shock And Personal injury
Hazard
Disconnect
electrical
supply before servicing
or cleaning
the vacuum
cleaner.
Failure to do
so could result in electrical shock or personal injury from vacuum
cleaner suddenly
starting.
CLEANING
EXTERIOR
AND ATTACHMENTS
1. Turn off and unplug vacuum cleaner. DO
NOT drip water on vacuum cleaner.
2. To clean exterior, or to reduce static elec-
tricity and dust build-up, wipe outer surface
of vacuum cleaner and attachments. Use a
clean, soft cloth that has been dipped in a
solution of mild liquid detergent and water,
then wrung dry. Wipe dry after cleaning.
Wash crevice
tool and dusting
brush in
warm soapy water, rinse and air dry.
Do not
clean in dishwasher.
CAUTION
Do not use attachments
if they are wet.
Attachments
used in dirty areas, such
as under a refrigerator,
should not be
used on other surfaces
until they are
washed. They could leave marks.
- 14 -

Publicidad

Tabla de contenido
loading

Tabla de contenido