Descargar Imprimir esta página

Helvex E-307 Guia De Instalacion página 4

Publicidad

Cambio de Manguera / Change Hose
Desenrosque el adaptador con la manguera , retire el contrapeso,
17
jale el cabezal junto con la manguera hasta retirarlo del cuerpo y
desenrosque el cabezal de la manguera.
adapter, remove the counterweight, pull the head with the hose to
remove the body and head unscrew the hose.
adaptador
adapter
counterweight
Posibles Causas y Soluciones / Possible Causes and Solutions
Problem a
/ Problem
La presión de operación no es la adecuada.
Existe poco flujo de
agua. /
There is some
water flow.
La salida está floja.
/ The
La tuerca espárrago no está
output is loose.
Hay fuga en las
conexiones.
/ There are
leaks in the
connections.
Participa en nuestros
cursos gratuitos
de capacitación.
Enter our free
training courses.
Recomendaciones de Limpieza / Cleaning Recommendations
Es muy importante seguir las siguientes instrucciones para conservar los
acabados de los
productos HELVEX, con brillo y en perfecto estado:
1. Utilice únicamente agua y un paño limpio.
2. No utilice fibras, polvos, abrasivos, ni productos químicos.
3. No utilice objetos punzo-cortantes para limpiar los acabados.
4. Se recomienda realizar la limpieza de su producto diariamente.
Nota: Vea nuestros tips en la pag. www.helvex.com.mx
HELVEX, S. A. DE C.V. Calzada Coltongo 293, Col. Industrial Vallejo 02300 Del. Azcapotzalco, México, D.F . T el. (55) 53-33-94-00.
/ Unscrew the hose
manguera retráctil
retractable hose
contrapeso
Causa
/ Cause
operating pressure is not adequate.
Las válvulas angulares no están totalmente
abiertas.
/ No angle valves are fully open.
apretada./ The stud
nut is tight.
Posiblemente no estén firmemente apretadas.
Possibly not tight.
Comunícate:
Contact:
En la Ciudad de México:
In Mexico City:
01 55 53 33 94 00
Ext. 5804, 5805 y 5806
Enrosque el cabezal y el adaptador a la nueva manguera e
18
insértela por el cuello del cuerpo, enrosque el adaptador de la
manguera al tubo de alimentación y coloque el contrapeso.
Screw the head and the adapter to the new hose and insert the
neck of the body, screw the hose adapter to the feeding tube and
place the counterweight.
cuello del
cuerpo
neck body
cabezal
head
head
tubo de
alimentación
feeder tube
/ The
Verifique que la presión mínima de operación sea 1,0 kg/cm².
Verify that the minimum operating pressure is 1,0 kg/cm².
Abrir totalmente las válvulas angulares. (Pag. 2, paso 10)
Instalación general.
Apriete firmemente la tuerca espárrago (Pag. 2, paso 4).
Apriete firmemente la conexión. (Pag. 2, pasos 6 a la 8)
/
Instalación de mangueras.
En Monterrey:
In Monterrey:
(0181) 83 33 57 67
(0181) 83 33 61 78
It is very important to follow the instructions below to preserve HELVEX products
finishes, shiny and in perfect condition:
1. Use only water and a clean cloth.
2. Do not use fibers, powders, abrasives, or chemicals.
3. Do not use sharp objects to clean the finish.
4. It is recommended to clean your product daily.
Note: See our tips on: www.helvex.com.mx
manguera retráctil
retractable hose
cabezal
head
Solución
/ Solution
/ Fully open angle valves. (Page 2, step
10) General installation.
Tighten the stud nut (Page 2, step 4).
/ Tighten the connection. (Page 2,
Steps 6 to 8) Install hoses.
En Guadalajara:
In Guadalajara:
(0133) 36 19 01 13
/
contrapeso
counterweight
/
4

Publicidad

loading