Bosch PKP 30 LE Manual Del Usuario página 6

Product Specification
Glue Gun
Part number
Rated power consumption
(heating)
Rated power consumption
(keeping warm)
Heating time
Glue temperature
Melting glue dia.
Melting glue length
Weight
Safety class
Machine Elements
1 Nozzle
2 Feed button
3 Charging station
4 Mains indicator
Not all of the accessories illustrated or described are
included as standard delivery.
For Your Safety
Working safely with this machine is
possible only when the operating
and safety information are read
completely and the instructions
contained therein are strictly fol-
lowed.
If the cable is damaged or cut through
while working, do not touch the cable
but immediately pull the mains plug.
Never use the machine with a dam-
aged cable.
A Danger of burning! The glue and the nozzle tip are
200 °C hot. Do not allow glue to come into contact
with persons or animals. If glue comes in contact
with the skin, immediately hold the spot under a
stream of cold water for some minutes. Do not try
to remove the glue from the skin. Seek medical
advice if severe.
The machine must not be damp and must also not
be operated in damp surroundings.
Children may use the hot glue gun only under su-
pervision of adults.
For pauses in the work of more than 30 minutes,
B
pull the mains plug.
Allow the unit to cool completely before storing.
The hot nozzle can cause damage.
Bosch can assure flawless functioning of the ma-
chine only when original accessories are used.
8
GB
PKP 30 LE Check for correct mains voltage: The voltage of
0 603 264 4.. the power source must agree with the voltage speci-
fied on the nameplate of the machine. Equipment
Approx. 500 W marked with 230 V can also be connected to 220 V.
Continuous Operation (figure
Approx. 30 W
The hot glue gun can be operated continuously with
Approx. 4 min
the mains plug inserted. The mains indicator 4 must
200 °C
light. During pauses in working, place the unit down
11 mm
on the folded out wire stand.
45 - 200 mm
0.37 kg Cordless Operation (figure
/ II
In conjunction with the charging station 3 , cordless
working is possible. If the emerging glue becomes
viscous, the hot glue gun is to be reheated in the
charging station.
Gluing Preparations (figure
Rough up smooth surfaces before gluing. The glued
position must be dry and free of dust or grease.
Heat the unit for approx. 4 minutes (figure
Glue Temperature
The temperature of the surroundings and the work
piece must be between 5 and 50 °C . Materials that
quickly cool the glue, e. g., metals, should be pre-
heated with a hot air gun.
Gluing (figure
– Insert a glue stick.
– Press the feed button 2 (figure
– Apply glue as required.
For the gluing of flexible materials (e. g. textiles), ap-
ply the glue in beads.
After the application of the glue, the work pieces
should be pressed together until the glue becomes
stiff. The glued location is capable of supporting a
load after approx. 5 minutes.
Protruding glue remains can be removed with a
sharp knife after the glue has cooled.
Glue locations can be loosened with heating. The
glued positions can be painted.
Nozzle Replacement
Heat the unit for approx. 4 minutes. Change the noz-
zle while warm.
Initial Operation
Operating Instructions
Do not use combustible solvents for cleaning.
D
Wear protective gloves.
Touch the nozzle only on the heat protec-
tion covering - the nozzle tip is hot!
C )
D )
)
C
E
- )
F
).
F
).